• IMPRINTING METHOD: Screen Printed.
Imprint cannot bleed , 1/16" unimprinted border required .

• MATERIAL : .032 thick Silver or Gold anodized aluminum
or .050 polar white aluminum.

• EXACT PLATE SIZES:  A tolerance of + or - 1/32" must be
allowed on all plates.
This is extremely important to customers
who will placing the plates into a recessed area
that the plate must fit.
A product proof is recommended if the plate
must fit into something.

•MOUNTING HOLES: Holes must be
located on corners or edge of plates.
For holes in other locations call factory.
Exact hole placement is not guaranteed: A tolerance of + or -
1/64" to edge of plate or  + or - 1/32" for hole center
to center must be allowed . Order a larger hole than needed
to compensate for this: e.g. need a 3/32" hole , order a 1/8"
hole to allow for the tolerances. This is extremely  important
to customers who will mounting plates on equipment with pre-drilled holes where the plate must match. A product proof is recommended in the instance. HOLE SIZES AVAILABLE
3/32", 1/8", 5/32, 3/16", 1/4"

•ROUNDED CORNERS: Sizes available:

•PRESSURE SENSITIVE MOUNTING TAPE:
Standard two-way tape is intended for clean, dry, smooth
and flat surfaces. 1/32" thick foam two-way tape is for clean, dry and flat surfaces that are lightly textured. If unsure, contact factory
for random samples to test on your application.

•CONSECUTIVE NUMBERING:

 

50	100	250	500	1000	2500	5000	10000
.80	.70	.40	.36	.30	.28	.24	.20 8(C)

•EXTREME CONDITIONS: For exposure to excessive heat,
oils, salt water, solvents etc., contact factory before ordering.

•PACKAGING: Individual Poly bags.

•LESS THAN MINIMUM: Absolute minimum quantity 125 pieces. Add $65(C) if item is under $2.00 and $40(C) if over
$2.00 LTM charge. Multi-color imprints are not available on LTM orders.

•PRODUCTION TIME: 5-10 Working Days.
Call factory if a deadline is required.

•SET UP CHARGE: $60(G)